Sun Microsystems 817-4054-15, Servise Manual

Page: 159 / 204

Chapter 10 IB_SSC Assembly 10-9
FIGURE 10-6
I/O Bay Location
10.2.1 Removing a I/O Card
Caution –
If you remove a I/O card and are not going to replace it, you must fit a
I/O card filler panel in its place to maintain EMI integrity.
1. Take the system to Standby mode.
See Section 4.2, “Taking the System to Standby Mode” on page 4-2 .
2. Make sure that the leveling feet are extended to the floor.
3. Extend and lock the system cabinet stabilizer bar.
See Section 3.1, “Sliding the System Out of the System Cabinet” on page 3-1 and
Section 3.2, “Sliding the System Into the System Cabinet” on page 3-5 .
Caution –
Failure to extend and lock the stabilizer bar before you slide a system out
of the rack will cause the system cabinet to tip over.
4. Slide the system out of the system cabinet until the locking latches click.
See Section 3.1, “Sliding the System Out of the System Cabinet” on page 3-1 .
5. Attach a wrist strap. Place a grounded ESD mat close to the system.
See Section 2.8, “Antistatic Precautions” on page 2-6 .
I/O bay
Front
Rear