Sun Microsystems 817-4054-15, Servise Manual

Page: 162 / 204

10-12 Sun Fire E2900 System Service Manual • May 2006
13. Reconnect the appropriate cable(s) into the I/O connector(s) at the rear of the
system.
14. Remove the antistatic wrist strap.
15. Slide the system into the system cabinet and secure it.
See Section 10.1, “IB_SSC Assembly” on page 10-1 .
16. Retract the system cabinet stabilizer bar.
17. Power on the system.
See Section 4.1, “Powering On the System” on page 4-1 .
10.2.2 Installing a I/O Card
Note – There are three versions of IB_SSC assemblies, PCI, PCI+ aned PCI-X.
Consult your Sun representative for cards supported by your version of the IB_SSC
assembly.
Caution –
This procedure requires the system to be extended out of the system
cabinet on its slides. You must extend the system cabinet stabilizer bar.
1. Take the system to Standby mode.
See Section 4.2, “Taking the System to Standby Mode” on page 4-2 .
2. Make sure that the leveling feet are extended to the floor.
3. Extend and lock the system cabinet stabilizer bar.
See Section 3.1, “Sliding the System Out of the System Cabinet” on page 3-1 and
Section 3.2, “Sliding the System Into the System Cabinet” on page 3-5 .
Caution –
Failure to extend and lock the stabilizer bar before you slide a system out
of the system cabinet can cause the system cabinet to tip over.
4. Slide the system out of the system cabinet until the locking latches click.
See Section 3.1, “Sliding the System Out of the System Cabinet” on page 3-1 .
5. Attach a wrist strap. Place a grounded ESD mat close to the system.
See Section 2.8, “Antistatic Precautions” on page 2-6 .
6. Open the I/O bay cover.