Sun Microsystems 817-4054-15, Servise Manual

Page: 61 / 204

Chapter 3 System Access and Transportation 3-13
Caution – Failure to extend and lock the stabilizer bar before you slide a system out
of the system cabinet can cause the system cabinet to tip over.
4. Extend the outer slides from the cabinet and latch them in the extended position.
5. With the lifting device supporting the weight of the system, raise the system until
it is level with the outer slides on the cabinet
(
FIGURE 3-9
)
.
6. Carefully move the lifting device forward until the slides on the system are fully
engaged with the outer slides on the cabinet (
FIGURE 3-9
).
The latches on each side must click out, locking the slides.
7. With the lifting device still supporting the weight of the system, loosen all eight
captive screws (
FIGURE 3-9
):
a. Loosen the upper four captive screws that secure the handle to the system.
b. Loosen the lower four captive screws that secure the handle to the cradle base
plate.
8. Pull both shipping cradle handles away from the system (
FIGURE 3-5
).
This disconnects the shipping cradle from the system. Store the shipping cradle for
future use.
9. Press the green latches on each slide. Push the system into the cabinet (
FIGURE 3-7
).
10. Tighten the two captive screws on the front of the system (
FIGURE 3-3
).
This secures the system in the cabinet.
11. Retract the cabinet stabilization mechanism (
FIGURE 3-1
).
12. Reattach the cable management arm (if applicable).
See Section 5.1, “CMA-Lite” on page 5-2 or Section 5.2, “CMA-800” on page 5-4 .
13. Reconnect all cabling. Use the cable management arm (if attached) to support and
protect the cabling.
14. Reattach the front bezel doors to the system (if applicable).