Sun Microsystems 817-4054-15, Servise Manual

Page: 167 / 204

Chapter 11 L2 Repeater Boards 11-3
8. Unlock the ejector levers with a Phillips no. 2 screwdriver (
FIGURE 11-2
).
The ejectors will pop out slightly.
FIGURE 11-2
Unlocking the
L2 Repeater
Board Ejector Levers
9. If you are removing the L2 Repeater board next to the media bay, lift the cover to
the media bay.
10. Raise the ejector levers simultaneously until they are 90 degrees straight out from
the board.
This action unseats the board from the connector.
11. Grasp the ejector levers and pull upward to raise the L2 Repeater board until the
green panels are visible (
FIGURE 11-3
).
The antigravity clutch holds the board in position so that it can be released without
the board sliding down into the system.
Note –
Any plastic green panels are parts that you can touch.