TO ENSURE YOUR USER INFORMATION IS UP TO DATE PLEASE DOWNLOAD THE LATEST VERSION OF THIS MANUAL FROM WWW.SUEX
Page 14 of 48
7.2 S
ETTINGS AND TRIM ADJUSTMENTS
According to salinity or water temperature, you may need to adjust the float or trim
settings (trim is the ADV longitudinal axis inclination).
As for floating, the ADV is produced to slightly float in both fresh water (without using
the ballast 23) and salt water (using the ballast 23).
As for trim, you can change factory settings by moving the battery along the rods (13)
(see fig.3). Remove the battery, loosen the nuts (21) with a 4 mm Allen key, unscrew or
screw in the ring nuts screwing it in, the ADV tends to position itself with the rear
sinking, unscrewing it causes the opposite. The two ring nuts must be positioned on the
rods (13) at the same distance. Screw in the nuts (21) without perforating, replace the
batteries and try the ADV in the water. Repeat the operation if needed until the desired
settings are reached.
8 S
AFETY INSTRUCTIONS
8.1 I
NDICATOR LABEL
The following indicator label is found on the vehicle. It should not be removed, tampered
with or destroyed. The user of the vehicle shall be responsible for replacing any worn
out or illegible label with a new one, it must be requested to our after-sales service.
SUEX S.r.l. will not be liable for damages and accidents happened in consequence of
behaviors in contradiction to the indications in it reported.
Summary of Contents for XJ37
Page 50: ......
