Subaru Tribeca 2010, Owner'S Manual

Page: 267 / 525

Black plate (163,1)
北 米
Model "A3150BE-A" EDITED: 2009/ 6/ 23
When the wiper switch is in the
“ ”
position, turn the dial to adjust the operat-
ing interval of the wiper.
The operating interval can be adjusted in
nine steps.
The intermittent operation interval varies
depending on the vehicle speed in any of
the adjustment steps (longer when the
vehicle speed is low; shorter when the
vehicle speed is high).
!
Washer
To wash the windshield, push the washer
button at the end of the wiper control lever.
The washer fluid sprays until you release
the washer button. The wipers operate
while you push the button.
NOTE
The windshield washer fluid warning
light illuminates when the washer fluid
level in the tank has dropped to the
lower limit. If the warning light illumi-
nates, refill the tank with fluid. For the
tank refilling method, refer to
“
Wind-
shield washer fluid
” F
11-32.
&
Rear window wiper and
washer switch
: Washer (accompanied by wiper operation)
ON: Continuous
INT: Intermittent
OFF: Off
: Washer
!
Rear wiper
To turn the rear wiper on, turn the knob on
the end of the wiper control lever upward
to the
“
INT
”
or
“
ON
”
position.
To turn the wiper off, return the knob on
the end of the lever to the
“
OFF
”
position.
With the switch turned to the
“
INT
”
position, the rear wiper will operate inter-
mittently at intervals corresponding to the
vehicle speed (longer when the vehicle
Instruments and controls
3-35
–
CONTINUED
–
3