Subaru Tribeca 2010, Owner'S Manual

Page: 222 / 525

Black plate (118,1)
北 米
Model "A3150BE-A" EDITED: 2009/ 6/ 23
2-18
Keys and doors
6. Push the front side (
“
LOCK
”
side) of
the power door locking switch to set the
door locks.
7. Close the door. An electronic chirp will
sound once, the turn signal lights will flash
once and the indicator lights will start
flashing rapidly. After rapid flashing for 30
seconds (standby time), the indicator
lights will then flash slowly (twice approxi-
mately every 2 seconds), indicating that
the system has been armed for surveil-
lance.
NOTE
.
The system can be armed even if the
engine hood, the windows and/or
moonroof are opened. Always make
sure that they are fully closed before
arming the system.
.
The 30-second standby time can be
eliminated if you prefer. Have it per-
formed by your SUBARU dealer.
.
The system is in the standby mode
for a 30-second period after locking the
doors with the remote transmitter. The
security indicator light will flash at
short intervals during this period.
.
If any of the following actions is
done during the standby period, the
system will not switch to the surveil-
lance state.
–
Doors are unlocked using the
remote transmitter.
–
Any of the doors or the rear gate
is opened.
–
Ignition switch is turned to the
“
ON
”
position.
&
Disarming the system
Briefly press the
“ ”
button (for less than
2 seconds) on the remote transmitter. The
driver
’
s door will unlock, an electronic
chirp will sound twice, the turn signal
lights will flash twice and the indicator
light will turn off.
To unlock all other doors and the rear
gate, briefly press the
“ ”
button a
second time within 5 seconds.
NOTE
If the interval between the first and
second presses of the
“ ”
button (for
unlocking of all of the doors and the
rear gate) is extremely short, the sys-
tem may not respond.
!
Emergency disarming
If you cannot disarm the system using the
transmitter (i.e. the transmitter is lost,
broken or the transmitter battery is too
weak), you can disarm the system without
using the transmitter.
The system can be disarmed if you turn
the ignition switch from the
“
LOCK
”
to the
“
ON
”
position with a registered key.
&
Valet mode
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the remote transmitter is used only
for locking and unlocking the doors and
rear gate and panic activation.
To enter the valet mode, change the
setting of your vehicle
’
s alarm system for
deactivation mode. Refer to
“
Activating
and deactivating the alarm system
” F
2-
16. The security indicator light will con-
tinue to flash once every 3 seconds
indicating that the system is in the valet
mode.