Subaru 2012 Legacy, User Manual

Page: 106 / 474

Black plate (107,1)
北 米
Model "A2480BE-A" EDITED: 2011/ 7/ 26
tically lock.
!
To arm the system using power
door locking switch
1. Close all windows.
2. Remove the key from the ignition
switch.
3. Open the doors and get out of the
vehicle.
4. Make sure that the engine hood is
locked.
5. Close the doors (and the rear gate
(Outback)) but leave only the driver
’
s door
or the front passenger
’
s door open.
6. Press the front side (
“
LOCK
”
side) of
the power door locking switch to set the
door locks.
7. Close the door. An electronic chirp will
sound once, the turn signal lights will flash
once and the security indicator light will
start flashing rapidly. After rapid flashing
for 30 seconds (standby time), the security
indicator light will then flash slowly (twice
approximately every 2 seconds), indicat-
ing that the system has been armed for
surveillance.
NOTE
.
The system can be armed even if the
engine hood, the windows and/or
moonroof are open. Always make sure
that they are fully closed before arming
the system.
.
The 30-second standby time can be
eliminated if you prefer. Have it per-
formed by your SUBARU dealer.
.
If your vehicle is a Legacy and you
open the trunk using the remote trans-
mitter
’
s
“ ”
button with the alarm
system armed, the system will be
temporarily placed in a standby state.
The system will go back to the surveil-
lance state upon locking the trunk.
.
The system is in the standby mode
for a 30-second period after locking the
doors with the remote transmitter. The
security indicator light will flash at
short intervals during this period.
.
If any of the following actions is
done during the standby period, the
system will not switch to the surveil-
lance state.
–
Doors are unlocked using the
remote transmitter.
–
Any door (including the rear gate
(Outback) or the trunk (Legacy)) is
opened.
–
Ignition switch is turned to the
“
ON
”
position.
&
Disarming the system
Briefly press the
“ ”
button (for less than
2 seconds) on the remote transmitter. The
driver
’
s door will unlock, an electronic
chirp will sound twice, the turn signal
lights will flash twice and the security
indicator light will turn off.
To unlock all other doors and the rear gate
(Outback), briefly press the
“ ”
button a
second time within 5 seconds.
!
Emergency disarming
If you cannot disarm the system using the
transmitter (i.e. the transmitter is lost,
broken or the transmitter battery is too
weak), you can disarm the system without
using the transmitter.
The system can be disarmed if you turn
the ignition switch from the
“
LOCK
”
to the
“
ON
”
position with a registered key.
Keys and doors
2-17
–
CONTINUED
–
2