Subaru 2012 Legacy, User Manual

Page: 165 / 474

Black plate (166,1)
北 米
Model "A2480BE-A" EDITED: 2011/ 7/ 26
3-46
Instruments and controls
!
Compass zone adjustment
Compass calibration zones
1. Refer to the
“
Compass calibration
zones
”
map shown above to verify that
the compass zone setting is correct for
your geographical location.
2. Press and hold the compass display
button for 3 seconds until the zone
selection comes up (a number will be
displayed in the mirror compass window).
3. Press the compass display button
repeatedly until the correct zone setting
for your location is displayed.
4. Releasing the button for 5 seconds will
exit the zone setting mode.
!
Compass calibration
1. If a
“
C
”
is displayed in the compass
window, the compass needs to be cali-
brated.
2. Drive the vehicle in a circle at 5 mph (8
km/h) or less until the display reads a
direction.
3. Your can also calibrate the compass
by driving your vehicle on your everyday
routine. The compass will be calibrated
once it has tracked a complete circle.
4. To recalibrate your compass, push and
hold the compass display button for 9
seconds until a
“
C
”
appears in the
compass window.
5. Calibrate the compass according to
step 2 or step 3.
!
HomeLink
®
Wireless Control Sys-
tem
The HomeLink
®
Wireless Control System
can be used to activate remote control
devices such as gate operators, garage
door openers, door locks, home lighting
and security systems.
There are three HomeLink
®
buttons on the
mirror, each of which can be programmed
for operation of one desired device. For
details on the device types which can be
operated by this system, consult the
HomeLink
®
website at:
www.homelink.com or call 1-800-355-
3515.
Note the following information about this
system.
If your vehicle is equipped with the
HomeLink
®
Wireless Control System, it
complies with Part 15 of the Federal
Communications Commission Rules in
the U.S. and the RSS-210 of Industry
Canada in Canada. Its operation is subject
to the following two conditions:
(1) this device may not cause harmful
interference, and (2) this device must
accept any interference received, includ-
ing interference that may cause undesired
operation.
Changes and modifications to this system
by anyone other than an authorized
service facility could void authorization to
use this equipment.
HomeLink
®
and the HomeLink
®
house are
registered trademarks of Johnson Con-
trols, Inc.
WARNING
.
W h e n p r o g r a m m i n g t h e
HomeLink
®
Wireless Control Sys-
tem, you may be operating a
garage door opener or other
device. Make sure that people