Subaru 2012 Legacy, User Manual

Page: 398 / 474

Black plate (407,1)
北 米
Model "A2480BE-A" EDITED: 2011/ 7/ 26
Alcohol contained in the clutch
fluid may damage them.
.
Be careful not to spill clutch fluid
when adding it. If clutch fluid
touches the exhaust pipe, it may
cause a bad smell, smoke, and/or
a fire. If clutch fluid gets on the
exhaust pipe, be sure to wipe it
off.
1)
“
MAX
”
level mark
2)
“
MIN
”
level mark
Check the fluid level on the outside of the
reservoir. If the level is below
“
MIN
”
level
mark, add the recommended clutch fluid
to
“
MAX
”
level mark.
Use only clutch fluid from a sealed
container.
&
Recommended clutch fluid
Refer to
“
Fluids
” F
12-8.
CAUTION
Never use different brands of clutch
fluid together. Also, avoid mixing
DOT 3 and DOT 4 brake fluids even if
they are the same brand.
Brake booster
If the brake booster does not operate as
described in the following procedure, have
it checked by your SUBARU dealer.
1. With the engine off, depress the brake
pedal several times, applying the same
pedal force each time. The distance the
pedal travels should not vary.
2. With the brake pedal depressed, start
the engine. The pedal should move
slightly down to the floor.
3. With the brake pedal depressed, stop
the engine and keep the pedal depressed
for 30 seconds. The pedal height should
not change.
4. Start the engine again and run for
approximately 1 minute then turn it off.
Depress the brake pedal several times to
check the brake booster. The brake
booster operates properly if the pedal
stroke decreases with each depression.
NOTE
When you depress the brake pedal
strongly or suddenly, the following
phenomena occur. However, even
though these occur, they do not indi-
cate any malfunctions, and the brake
assist system is operating properly.
.
You might feel that the brake pedal
Maintenance and service
11-27
–
CONTINUED
–
11