Subaru 2012 Legacy, User Manual

Page: 105 / 474

Black plate (106,1)
北 米
Model "A2480BE-A" EDITED: 2011/ 7/ 26
2-16
Keys and doors
1 second, and wait 10 seconds without
releasing the switch. The setting will then
be changed as follows:
If the system was previously activated:
The trip meter screen displays
“
AL oF
”
and the horn sounds twice, indicating that
the system is now deactivated.
If the system was previously deacti-
vated:
The trip meter screen displays
“
AL on
”
and
the horn sounds once, indicating that the
system is now activated.
NOTE
You may have the above setting
change done by your SUBARU dealer.
&
If you have accidentally trig-
gered the alarm system
!
To stop the alarm
Perform any of the following operations.
.
Press any button on the remote trans-
mitter.
.
Turn the ignition switch to the
“
ON
”
position.
&
Arming the system
!
To arm the system using remote
transmitter
1. Close all windows and the moonroof (if
equipped).
2. Remove the key from the ignition
switch.
3. Open the doors and get out of the
vehicle.
4. Make sure that the engine hood (and
the trunk lid (Legacy)) are locked.
5. Close all doors (and the rear gate
(Outback)).
: Press to Arm the system.
: Press to Disarm the system.
Security indicator light
6. Briefly press the
“ ”
button (for less
than 2 seconds). All doors (and the rear
gate (Outback)) will lock, an electronic
chirp will sound once, the turn signal lights
will flash once, and the security indicator
light will start flashing rapidly. After rapid
flashing for 30 seconds (standby time), the
security indicator light will then flash
slowly (twice approximately every 2 sec-
onds), indicating that the system has been
armed for surveillance.
If any of the doors (rear gate or trunk lid) is
not fully closed, an electronic chirp sounds
five times, the turn signal lights flash five
times to alert you that the doors (or the
rear gate) are not properly closed. When
you close the door, the system will
automatically arm and doors will automa-