-
46
-
© STULZ GmbH, Hamburg
-
46
-
9.2.3 Reading the available measurements
To directly display one of the available measurements, press the corresponding button (Fig. 9.2.3.1) twice.
Fig. 9.2.3.1
9.2.4 Modifying the main parameters (with specific button)
With reference to Fig. 9.2.4.1:
• perform the operations for starting parameter programming (see paragraph 9.2.1 or 9.2.2);
• press either the + or - button corresponding to the parameter to be modified; the display shows the parameter code;
• press the SEL button again to display the value;
• then press the + or - button to increase or decrease the value.
The values in the memory of the control module will automatically be modified on exiting the programming phase (para-
graph 9.3).
Fig. 9.2.4.1
9.2.5 Modifying the main parameters (without specific button)
The parameters without a specific button can also be modified, proceeding as follows:
• perform the operations for starting parameter programming (see paragraph 9.2.1 or 9.2.2);
• press the
s
or
t
, button until the code of the required parameter is displayed;
• press the SEL button to display its value; then press
s
or
t
, again to increase or decrease the value; finally, press
SEL to temporarily confirm the new value;
• to modify other parameters, repeat the same operations.
9.3 Exiting the programming phase
To exit the programming phase and save the modifications made to the parameters, press the PRG button.
To exit without saving the modifications, press the ESC button.
To exit the programming phase without confirming the modifications made:
• do not press any button for 60 seconds, if the parameter code is displayed;
• do not press any button for 120 seconds, if the value of the parameter is displayed.
