-
18
-
© STULZ GmbH, Hamburg
-
18
-
A
22
30
40
B
10
10
10
Y
58
68
89
35
45
60
X
68
77
99
B
Y
X
A
X
°2
.
5.3 Steam distribution in ducts - linear and concentrated jet distributors (OEM)
The humidifier may be used for small ducts with a static pressure of no greater than 500 Pa. For steam distribution into air
ducts, the steam distributor must be sized according to the output of the humidifier and the cross-section of the ducting. For
this purpose, STULZ supplies two ranges of linear distributors: one in aluminium, with plastic ends. Figures 5.3.1 provide
the dimensions of the STULZ distributors, while table 5.3.1 specifies the minimum number and the model of the distributor
recommended for the type of humidifier used.
Tab. 5.3.1
N.B.:
If the duct is not wide enough for the steam distributor, it is possible to split the steam hose to allow the usage of
multiple steam distributors (number in brackets).
* : “Y” kit available for dividing the steam hose, with 40 mm dia. inlet and 2 x 30 mm dia. outlets, (K87245)
**: “Y” kit available, 40 x 40 x 40, for spitting the steam hose
DP***D**R0 – linear distributors
Fig. 5.3.1
Fig. 5.3.2
fasten the support where envisaged
dimensions in mm
flange gasket
steam inlet
condensate drain
screws max. dia “M5”
L (see table 5.3.1)
hole in wall
Use the fastening support, supplied,
to ensure the 2° gradient due to the
shape of the flange.
humidifier fitting Ø mm
humidifier capacity
kg/h
code
distr
ib
utor fitting mm
(øA)
max.
distr
ib
utor capacity
kg/h
length (L) mm
SEH001
SEH003
SEH005
SEH008
SEH010
SEH015
SEH025
SEH035
SEH045
SEH065
