Stryker SwitchPoint Infinity 3, Operation And Maintenance Manual

Page: 53 / 124

51
To select another endpoint(s) to broadcast to, repeat the above procedure for each
endpoint, selecting that endpoint name from the “Room Name” drop down menu.
To disconnect a Broadcast call, press the red H Ha an ng g U Up p button on the Active Call
interface.
10.13.2View Only
A View Only call is initiated from the Manual Dial interface or can be stored as a preset
and initiated from the Call Groups interface.
To create a View Only call:
1. Navigate to the Manual Dial interface and select Room Call from the “Connection
Type” drop down menu.
2. Select View Only from the “Connection Method” drop down menu.
3. Select the endpoint that is broadcasting from the “Room Name” drop down menu.
4. Press the green C Ca allll button to initiate the View Only call.
An endpoint can only view one broadcast call at a time.
To disconnect from a View Only call, press the red H Ha an ng g U Up p button on the Active Call
interface.
10.13.3Meeting Room
The Meeting Room call feature is only available on an ORIS equipped with a Video
Network Hub that has the Meeting Room option installed. If these features are available
within the ORIS, the SwitchPoint Infinity 3 Control System is automatically capable of
using them, and no additional configuration is necessary.
A Meeting Room call is any call that consists of more than two endpoints exchanging
two-way audio and video. The Meeting Room call feature supports a maximum of four
endpoints. It is capable of using the Codec within the Video Network Hub as one
endpoint, allowing up to three local and one remote endpoint to participate in a Meeting
Room call.
A Meeting Room call is initiated from the Manual Dial interface or can be stored as a
preset and initiated from the Call Groups interface.
To create a Meeting Room call:
1. Navigate to the Manual Dial interface and select Room Call from the “Connection
Type” drop down menu.
2. Select Broadcast from the “Connection Method” drop down menu.
3. Select the first endpoint that is participating in the Meeting Room call from the “Room
Name” drop down menu.
4. Press the green C Ca allll button to initiate the call.
5. Navigate to the Manual Dial interface and repeat the above steps until all desired
endpoints are connected to the Meeting Room call.