Stryker SwitchPoint Infinity 3, Operation And Maintenance Manual

Page: 26 / 124

24
7
������� �����
The options on the Simple Routing screen allow you to route images from various
cameras or video input devices in the iSuite® OR to devices or monitors connected to the
SwitchPoint Infinity 3 Control System. This screen can be used to select which video
source to direct to a remote room or offsite location using the Video Network Hub or
SuiteLink. This screen is the default page for the Home screen.
The SwitchPoint Infinity 3 Control System manages video routing as a chain of events.
Once a video source is selected, it can be routed to a number of devices or displays in a
row. This simplifies the process and allows the same input source to be viewed and
recorded in multiple ways.
The SwitchPoint Infinity 3 Control System gives special distinction to devices such as the
Stryker Digital Capture (SDC) and Sidne. These devices are capable of receiving video
signals, but their output can be re-routed to a display so that the surgeon can view what
is currently being recorded on a given documentation device.
There are three ways in which video can be routed, each of which are described in the
sections that follow.
7.1 Simple Routing
The Simple Routing screen appears similar to the one shown in the figure below, and is
also known as the “Simple Routing” page. This screen contains four main components:
the sources are listed on the left side of the screen; the devices through which the
sources can be routed are listed at the top of the screen; the displays on which the video
signal can be displayed are located on the right side of the screen; and the video stream
being routed will be displayed in the video preview pane in the center of the screen.