Stryker CUB FL19H, Maintenance Manual

Page: 24 / 152

• 9/16” socket
• 1/2” combination wrench
• 9/16” combination wrench
• Spring compression tool (1210-001-003)
• OG2 grease (M0027)
P Prro occe ed du urre e::
1. Remove the litter. See Litter removal, hydraulic base (page 37).
2. Lower the jacks all the way down using the appropriate release pedal.
3. Move the base from underneath the supported litter to an appropriate work area.
4. Lift the base hood.
5. Separate the V Ve ellccrro o® fasteners that secure the base hood to the base.
6. Using a 1/2” combination wrench and 1/2” socket, remove the locknut and bolt that link the activation bar to the pump
piston. Save the locknut and bolt.
7. Using a spring compression tool, compress the pump spring of the jack that needs replacement.
8. Remove the spring and shoulder socket from the pump piston. Save the spring and shoulder socket.
N No otte e -- Apply OG2 grease to the spring before installation.
9. Using a 1/2” combination wrench and 1/2” socket, remove the two locknuts and two bolts that secure the jack clamp to
the frame. Save the locknuts and bolts.
10. Using a 9/16” combination wrench and 9/16” socket, remove the four locknuts, four washers, and four bolts that secure
the jack base to the base frame. Support the jack base before you remove the fasteners. Save all parts.
11. Remove and discard the jack. Use caution as the release valve pin is still connected to the descent lever.
12. Install the spring holder and safety stop on the new jack.
13. Reverse steps to reinstall.
14. Adjust the jack descent rate. See Constant flow jack descent rate adjustment, hydraulic base (page 23).
15. Verify proper operation before you return the product to service.
H Hyyd drra au ulliicc ffllu uiid d lle evve ell cch he ecckk,, h hyyd drra au ulliicc b ba asse e
C CA AU UT TIIO ON N -- Do not use hydraulic fluids other than the recommended M Mo ob biill™ Aero HFA to avoid the risk of jack damage.
T To oo ollss rre eq qu uiirre ed d::
• (2) Bungee cords (or equivalent)
• 3/4” socket
• M Mo ob biill™ Aero HFA hydraulic fluid (2020-070-475)
P Prro occe ed du urre e::
1. Raise the rails to the highest position.
2. Lower the litter to the lowest height.
3. Apply the brakes.
4. Make sure that there are no hydraulic fluid leaks. If leaks are present, replace the jack. See Hydraulic jack replacement,
hydraulic base
(page 21).
5. Remove the bottom part of the bellows from the base hood.
6. Using bungee cords, support the bottom part of the bellows to gain access to the fill plug.
EN 22 1900-009-002 Rev AA.6