Stryker CUB FL19H, Maintenance Manual

Page: 29 / 152

P Prro occe ed du urre e::
1. Raise the litter and the rails to the highest position.
2. Apply the brakes.
3. Using a floor jack, raise the side of the product with the pedal that needs repair approximately four inches off the floor.
4. Using a drill with a 3/16” drill bit, remove the two rivets and two washers (B) that secure the pedal to the pedal rod
(Figure 14).
5. Align the holes on the new pump pedal and the pedal rod. Fit the pump pedal on the pedal rod.
6. Using a pop rivet tool, install the new uni-lower pedal.
7. Verify proper operation before you return the product to service.
S Scca alle e m me em mb brra an ne e rre ep plla acce em me en ntt
T To oo ollss rre eq qu uiirre ed d::
• Small regular screwdriver
• Isopropyl alcohol
P Prro occe ed du urre e::
1. Slide a small regular screwdriver under the membrane (A) and lift to remove (Figure 15). Use caution when you insert
the screwdriver under the membrane to avoid scratching the plastic cover.
D
D
C
B
A
E
K
L
G
H
J
M
N
F
P
R
S
T
F Fiig gu urre e 1 15 5 –– S Scca alle e m me em mb brra an ne e rre ep plla acce em me en ntt
2. Using isopropyl alcohol, remove any glue residue.
3. Remove the protective film on the backside of the new membrane and place it on the cover. Position the membrane
before you permanently adhere it to the cover.
4. Verify proper operation before you return the product to service.
1900-009-002 Rev AA.6 27 EN