Stryker 747, Operation Manual

Page: 27 / 427

English
EN
www.stryker.com 0747-109-005 REV A 1-21
Accessories
Positioning the two-stage permanently attached IV pole option (Continued)
A
B
C
A
Figure 1-8: Positioning the 2 stage permanently attached IV pole
Positioning the three-stage permanently attached IV pole option
WARNING
Do not use the IV pole as a push/pull device. Product damage may occur.
You can purchase the product with the three-stage IV pole option permanently attached at the head end, foot end, or
both ends of the product. The IV pole is equipped with a telescopic pole that extends to provide a second and third
height position. You can also fold and store the IV pole when not in use.
To position the three-stage IV pole ( Figure 1-9 on page 1-22 ):
1. Lift and pivot the pole from the storage position.
2. Push the IV pole down until the pole locks in place.
3. To raise the height of the IV pole, pull up on the telescoping portion (A) until the pole locks into place at the fully
raised position.
4. For a higher IV pole, pull up on section (B). Release section (B) at any desired height to lock the pole in place.
5. Rotate the IV hangers (C) to the desired position and hang the IV bags.
6. To lower the IV pole, push up on the yellow portion of the grip (D) while holding on to section (B) until the pole
lowers.
7. Turn the latch (E) and lower the IV pole telescoping portion.
Notes
• Do not hang IV bags that exceed 12 lb (5 kg) total for all bags on the IV pole.
• Do not hang IV bags that exceed 9.3 lb (4.2 kg) on a single IV hanger.
• Always make sure that the IV pole is at a low height to allow the pole to pass safely through door openings
when you transport a patient.