PART 1
z
English
39
The receiver displays the
message “
No or Bad signal
”
The receiver displays the
message “
No or Bad signal
”
The receiver displays the
message “
No or Bad signal
”
The RED and Green lights
on the front panel of your
receiver are blinking
The remote control is not
working
No audio/ sound on a one
TV channel
Wrong satellite selected in
the menu
Wrong parameters set in the
menu
Wrong alignment of the dish
Overload of the maximum
available LNB power. (Short
circuit in the LNB cable)
The batteries of the remote
control are not inserted or
exhausted
This channel is programmed
on AC 3 audio. This disabled
the normal audio out put to
TV - set
Press the SAT button on the RCU and
select the correct satellite
Check settings in LNB- and Channel set up
menu
Ask your dealer to check the outdoor unit
and antenna coaxial cable or F-connector to
LNB
Disconnect the 220 V main power and ask
your dealer to check the LNB cable
Check whether the batteries are inserted
correctly in your remote control. Check the
batteries, and if they are exhausted, replace
them
Select TV channel, press AUDIO button,
select normal audio
