PART 1
z
English
8
2.2 Rear Panel
(Please see inside cover Figure 2)
1. SAT IN
Connect the I.F. digital signal from your LNB of your satellite dish to this connector.
2. SAT OUT
Gives you the possibility to connect an extra receiver (analogue or digital).
3. AUDIO Right (Red RCA) and Left (White RCA)
These connectors give you the possibility to connect the audio signal to an external amplifier
or to the audio input of your TV.
4.VIDEO (YELLOW RCA)
This connector has a constant video signal for additional VCR-connections
5.TV Scart Connector
Use this connector to connect your receiver to your TV using a scart cable.
6.VIDEO Scart Connector
Use this connector to connect your receiver to your video recorder using a scart cable. Your
video signal will now be looped through to your TV.
7. IR SENSOR
Use this connector to connect an external remote eye if you wish to store your receiver in a
place where the IR on your receiver cannot communicate with the remote. For example, if you
wish to put your receiver in a closed environment such as a well ventilated closet, then this
accessory will be useful because it can allow the remote control to control the receiver through
the remote eye.
8. RS 232 Serial Port
This serial port can be used to connect your PC to your receiver, and enables you to download
new versions of software into your receiver. Detailed information about downloading software
into your receiver can be found on our website (www.strongsat.com).
Note:
It is recommended to ONLY use the original software provided via our website. Loading other
versions of software not adapted to your model number can cause severe damage to your
receiver, and will not be covered by the warranty.
9. ANT IN
RF Modulator (female part). If you have cable TV or if you have an outdoor antenna, then you
can connect the RF cable coming from the antenna or wall connector to this ANT input. If you
use a scart cable to connect the receiver to your TV, the additional antenna can be put directly
into your TV.
