Strong SRT 6160 PDR, User Manual

Page: 31 / 49

PART 1
z
English
25
The Scan options:
At the bottom of the screen you will find the four colored buttons, each button represents a specific
“ scan ” function:
„
AutoScan (RED Button): This function searches all the transponders of a satellite.
„
Net. Scan (GREEN Button): “
Network Search
” Performs network search for a transponder.
„
TP Scan (YELLOW Button): Search channels from current specific transponder.
„ PID (BLUE Button): You can search a specific channel by entering the PID value of a
channel. If you press the BLUE (PID) button, the PID screen is displayed. Enter the PID
value and press the BLUE button again. A screen (PID search) will now be displayed and
shows the status of the search. (see cover page 23)
„
Press the BACK Button to return to the “ Channel installation ” menu.
Tip: Check the level and quality of the signal bar before searching any channels. The signal level of
the TP of the current satellite is displayed. The green bar is displayed if the settings are correct,
otherwise the red bar is displayed and you cannot get the channel. In the latter case, check if
your dish is aimed at the selected satellite or if the DiSEqC switch of the LNB overlaps with
another satellite. Also, change the Frequency with the LEFT/RIGHT button until the Green bar
is displayed to get the valid transponder. If you press the RED (Auto Scan), GREEN (Net.
Scan), YELLOW (TP Scan), or BLUE (PID) button the channel searching status is displayed.
(Please see inside cover Screen 22)
5.1.4.4.1 Positioner Set-up (if you are using a Motorised positioner with
DiSEqC1.2)
(Please see inside cover Screen 24)
If you are using a motorized DiSEqC 1.2 Dish you will need to set the positions of the different satellites.
This function is available only if in the “ LNB Set-up ” menu and the LNB Dish field is set to “ Moved ”.
(As described in “ LNB Set-up ” Described in section 5.1.4.3).
Before you start:
1. Make sure that your installer has set the centre position of your dish.
2. Make sure that the mechanical limits of your motor are set, so that no damage can be done
to your dish by moving it too far to the East/West.
3. Make sure you set the highest Symbol Rate (Ksymbols/sec) for your chosen transponder
(TP). The Signal level and Quality indicator will help you set up the best dish position possible.
4. Use your UP/DOWN buttons to select the “ Dish Position " field in the “ Channel Set-up ” menu.
5. Press the OK button and the “ Positioner Set-up ” Menu will be displayed.
6. Start setting the position of the selected satellite.