PART 1
z
English
17
Ending Time:
You can set the ending time of the channel view when the Timer mode is
on Recording.
Channel:
You can select the channel to be shown when the receiver timer mode Powers ON
Press
OK
, now you will see the channel list, select a channel and Press
OK
4. Press the
RED
button to save and proceed with another timer event
5. Press the
GREEN
button to save and exit the timer menu
6. Press the
YELLOW
button to exit the timer menu WITHOUT saving the settings
7. Press the
BLUE
button to display the list with set timer events, you can remove wrong or
unneeded events.
Press
BACK
to return from the timer events list.
Tip:
You have to select the channel, starting time, and ending time settings if the Timer mode is
“
Recording
”. An error mes¬sage will appear if any of the settings are incorrect. Disconnecting
the receiver from mains power (or switching it OFF by using the main power witch at the back
panel of the receiver) will cause incorrect or disable timer functions.
Timer Programming Via EPG:
The programming for recordings on the Hard-Disk can be set up in a easy way by using the Electronic
Programme Guide (EPG).
1. Press the
EPG
button on your remote control
2. Select with the
UP/DOWN
or
LEFT/RIGHT
button the programme that you want to record.
3. Open with the
BLUE
button the Timer menu
4. The corresponding data is now present in the Timer menu.
5. Manual adjustments are possible, for example if you want to extend the duration of the
recording.
6. Safe the settings with the
RED
button.
7. Press the
BLUE
button to display the list with set timer events, you can remove wrong or
unwanted events.
8. Press
BACK
to return from the timer events list.
9. Exit the timer menu by pressing the
GREEN
button (
Save
) or
YELLOW
button (last changes
will not be saved).
