Street Crane ZX6, Installation, Operation And Maintenance Instructions

Page: 62 / 103

d e f g h
© Street Crane Co Ltd
Page 62 of 103 Ref: D3256 rev. B

Fit the socket head capscrew to the non ‐ spring side inserting the plastic washer between the two halves
of the rope band. Tighten to 1.5Nm.

Position the inner band assembly over the rope such that 2 free rope coils remain unclamped and
tighten the capscrew on the spring side 1.5Nm (see Figure 42).
1
Ensure all slack rope is removed prior to tightening inner band fixings. It should not be possible
to slide or rotate the inner band over the rope without using excessive force. If the inner band
is moved easily, remove one or both plastic washers from the inner band joint.
Figure 42 – Rope Guide Inner Band Fitted

Lightly lubricate the location groove on both halves of the outer band (see section 5.7.1).

Fit the bottom half of the outer band (tapped joint holes) over the inner band and rotate until it is on
the underside of the barrel ensuring that the slot collects the rope which leaves the barrel (see Figure
43).
Figure 43 – Fitting Rope Guide Outer Band

Fit the top half of the rope guide over the inner band. Insert the four socket head capscrews and screw
two halves together. Tighten to 1.5Nm.

FOR STANDARD ENVIRONMENT ROPE GUIDES type Rv ‐ 1: ‐ Fit the rope guide retainer to the face of the
rope guide. Tighten the screws to 8Nm (see Figure 44).

Set the upper and lower limit switches (see Section 3.6)