Wing Construction Cont.
☐
Note that there is a relief in the top of the slot
to allow the head of the blind nut to pass
through the rib.
☐
Fit one rib R2 to trailing edge and left side of
W6. Do not bond.
☐
Fit the other rib R2 in the same manner.
Square structure on a flat surface and bond
all joints with medium CA, building up a fillet
along all joints between ribs and W6.
☐
Fit and tack glue remaining ribs R3 and R4.
☐
Fit upper front spar part W1a to notches in
ribs R1-R4. Do not bond.
☐
In the same manner, fit lower front spar part
W1a to notches in ribs R1-R4.
RingRat 250 © 2010 Stevens AeroModel all rights reserved.
Page 9 of 29