© 2008 Stevens AeroModel.
Page 16 of 52
17. With the fuselage supported on your flat work table locate the 1/16 in ply parts F6, F7, and F8 (sheet 20/21).
These parts also have a top and forward designation etched on them. Pay careful attention to the part
orientation as you install and tack glue these to the fuselage assembly in their corresponding positions.
18. Install the 1/16 in. balsa aft cross grain doubler F13 (sheet 12/21) register part against the inside aft surface of
former F5 and F14 aligning the 3/16 in. hole in the doubler with the matching hole in the fuselage sides as
illustrated below. Bond part using medium CA glue.
19. Complete aft end of fuselage by installing 1/16 in. balsa part F15 (assembled in step 1) aligning tabs in former
with notches in fuselage. F15 spans former F5 to the tail of the fuselage assembly. Tack glue to retain part.
