![background image](http://html.mh-extra.com/html/stertil-koni/st-1082-f-bat/st-1082-f-bat_installation-operation-and-service-manual_1375430022.webp)
18
Fig 5.7 Pallet lifting mechanism
5.7
OPERATING THE PALLET LIFTING MECHANISM
1. Set the lever to position (3) and make a pumping movement with the
drawbar, to raise the column lift with the pallet lifting mechanism. The
column lift can then be relocated.
2. Pull the lever to position (1) to lower the column lift to the floor.
3. Set the pallet lifting mechanism in the lowest position, and the lever to
the neutral position (2), whenever the column lift is to be used to hoist a
vehicle
.
5.8
USING OUTDOORS
When using the lifting system outdoors you must be aware of the admissible wind speed.
The admissible wind speeds for different types of vehicle are shown in the table below.
The values in the table are average values and should only be used as a guide.
The admissible wind speed is dependent on the type as well as the weight of the vehicle.
When lifting large high-sided vehicles, the value for lighter vehicles must be used.
The operator must consider all factors when deciding if it is safe to use the lifting system
If any doubt exists, always use the lower wind speed.
Vehicle Type
Weight (empty)
metric tons
lbs
Max. admissible wind speed
mtr/s on side of vehicle
miles/h
Beaufort
Light cars or lorries with
long swop bodies.
4.5 - 10
10,000 - 22,000
14
32
6
Buses
10 - 15
22,000 - 33,000
20
45
8
Lorries and
Heavy vehicles
>> 10
>> 22,000
24
54
10
WARNING: Do not expose to rain, see also important safety
instructions.
Summary of Contents for ST 1082-F/BAT
