![background image](http://html.mh-extra.com/html/stertil-koni/st-1082-f-bat/st-1082-f-bat_installation-operation-and-service-manual_1375430024.webp)
20
6.
OPERATION
The assembled lifting system must be checked for correct working and adjustments and a complete operational test
should be carried out by using a typical vehicle.
Remarks:
- When using this lifting system leave a space for a 24" wide passage around the lifting system which can serve as
escape route.
- Before using the Mobile Lifting Columns, ensure that the maximum load for each lifting column is not more
than 18,000 lbs.
- Ensure that before use, the lifting system is placed vertically seen from the sides as well as from the front.
- Refer to section 5.7 for lifting system wind speed limits.
- Refer to section 5.8 for vehicle technology.
- Make sure that the pallet jack mechanism it is fully lowered before lifting a vehicle.
6.1
PREPARATION
1. Adjust the forks to the required distance, See section 5.6. (Only adjustable forks)
2. Place the required number of lifting columns.
3. Ensure that the fork of each lifting column is slid around the wheel as far as possible.
4. Lower the pallet jack mechanism by lifting the lever inside the tow bar.
5. Make sure the main switch on the lifting columns is set to 0 (OFF).
6. Connect the connecting cable between the lifting columns in a closed circuit.
7. Make sure that the Emergency Release buttons are unlocked on all the lifting columns.
8. Set the main switch to position 1 (ON), on ALL columns
9. Push the “SET REF”-button. Make sure the control voltage and the main supply light are on.
10. Check the mechanical safety lock.
11. Once desired height has been reached, it is recommended but not required that the lift be lowered into the mechanical
locks.
12. Once desired height has been reached turn main switches to 0 (OFF)
WARNING: Turn off the main switch when the columns
are not used. If not, the control system will slowly drain
the batteries completely, resulting in damaged or
defective batteries
6.2
RAISING AND LOWERING ALL LIFTING COLUMNS
See section 5, paragraph 5.3: Description of the mobile column lift system.
6.3
RAISING AND LOWERING OF TWO LIFTING COLUMNS
(ONE VEHICLE AXLE); PAIRED OPERATION
See section 5, paragraph 5.3: Description of the mobile column lift system.
6.4
RAISING AND LOWERING A SINGLE LIFTING COLUMN
See section 5, paragraph 5.3: Description of the mobile column lift system.
Summary of Contents for ST 1082-F/BAT
