11
AlphaCom XE - Installation, Configuration & Operation
A100K10805
The optional program connection board or LCM module has input
●
for 6 Remote Control Inputs (RCIs) which can initiate programmed
actions.
The server is powered from the mains. The power supply, APWR,
●
runs on 90-270 VAC.
The server provides room for 3 power supplies but is delivered with one.
If more than 102 stations are to be connected, a second power supply
must be mounted. A third power supply may be installed for redundancy.
The active load sharing ensures that each power supply shares the load
equally /- 5% when more than one power supply is installed in
the system. If one power supply fails, the other(s) will take over and
keep the server running.
LCM - Line Connection Module
2.2.5
See the manual
A110K10610 Line Connection Module
for more details.
The Line Connection Module (LCM) is used for external connections for
AlphaCom XE servers with any mix of ASLT, ATLB and ATLB12 boards.
LCM is not used with XE1 and normally not used with XE7 as this server
has line connections on the backplane.
One module serves 6 subscriber boards (36 intercom stations). Up to 4
modules may be needed in a fully equipped XE26 server.
The module(s) must be mounted to DIN rail(s) on the server termination
field and connected to the server according to the project configuration.
The LCM board will substitute
6 x Subscriber Connection boards (100 9930 200)
-
Power Distribution board (100 9970 101)
-
MRBD, Relay board with 6 RCO relays (100 9970 200)
-
FBSAR, Filter and Speech Adapter board with 2 audio outputs, 1
-
audio input and PTT relay if these functions are used. (100 9505
000)
Each LCM board has connectors for
24 VDC Power
●
Input
-
Output
-
3 x fused outputs
-
6 x fused relay controlled RCO outputs (switch selection)
-
Line-points
●
All subscriber line connections are made to the LCM board.
Any mix of ASLT, ATLB and ATLB-12 boards may be used.
Max. 36 analog intercom stations with 6 x ASLT boards
-
Max. 72 analog telephone lines with 6 X ATLB-12 boards
-
RCO
●
6 x relay contacts, potential-free or +24 V (switch selection)
-
6 x output to optional MRBD Relay board
-
RCI
●
1)
6 x closing contact inputs referred to 0 V.
-
Audio program inputs
●
1)
6 x galvanic isolated 600 ohm, 0 dB lines
-
Radio / Walkie-Talkie interface
●
1)
Galvanic isolated adjustable audio in and out
-
RCO relay can be used for PTT control
-
PA audio output
●
Audio output for PA with monitor intercom station in parallel
-
1)
The APC board must be connected to Line board connector 6.
Not used in AlphaCom XE7
1
2
3
4
5
6
1
6
12
13
18
19
24
25
30
31
36
3
2
1
3
2
1
7
RCO
1-
6
RCO
7-
12
Li
ne B
oar
d 1
Li
ne B
oar
d 3
Li
ne B
oar
d 4
Li
ne B
oar
d 5
Li
ne B
oar
d 6
Li
ne B
oar
d 2
RCI
P
rog
.
24
V
in
2
4V
a
ux
R
el
ay