30
PUMP TUBE
CENTER THE TUBE
1.
Ensure the pump is off. Lift the latch located between the tube fittings, leaving the
end of the latch engaged with the lip on the tube housing cover. Leave the latch on
the opposite side engaged.
Figure R
2.
Plug the pump in and turn it on. Turn the tube fitting on the suction side not more
than 1/8 of a turn in the direction tube must move.
Figure S
3.
DO NOT let go of fitting until tube rides approximately in center of rollers.
4.
Turn the pump off, let go of the fitting, and secure the latch between the fittings.
Figure T
For CE pump only: Reinstall the safety screw on the cover.
5.
Inspect the suction and discharge lines, point of injection, and check valve duckbill
for blockages. Clean and/or replace as required.
6.
Reconnect the suction and discharge lines. DO NOT allow tube fittings to turn inside
the pump housing.
7.
Turn the pump on and verify operation.
TUBE REPLACEMENT
continued
www.stenner.com
R
S
T