Maintenance Manual STEMME S10-VT
Date of Issue: Dec. 19, 1997
Page: 5-13
Amendment No.: 23
Date: Jan. 29, 2015
A4011121_B23.doc
Doc. No. A40-11-121
5.4 Check List for Periodical Inspections
NOTE:
Read maintenance instructions in sections 6 and 7 before carrying out adjustments! Additionally to
maintenance instructions, these sections indicate special maintenance intervals (2 years) allowable
for some items of the type 3 inspection program in the following check list.
WARNING:
Prior to any maintenance work switch
OFF
Master Switch and Ignition!
For explanation of type of inspection refer to section 5.3.1 and 5.3.4.
Type and Subject of Inspection
B
re
a
k
-In
A
/C
1
0
0
h
E
n
g
ine
1
0
0
h
E
n
g
ine
2
0
0
h
E
n
g
ine
6
0
0
h
A
n
n
u
a
l
refer to
section
Sign-off
5.4.1 General
1. Thoroughly clean a/c and engine, remove or open all necessary
inspection plates, access doors, fairings and cowlings
X X
X
-
2. Inspect a/c surfaces and markings (especially registration and
national flag), renew if necessary.
X X
X
6.6,
7.1
3. Check all drain and ventilation holes (see position plan section
6.7).
X X
X
6.7
4. Check all points of lubrication and grease if required (ref. to
section 6.5)
X X
X
6.5
5. Check function of flight controls
X X
X
7.3
6. Check slackness of aileron, flap and elevator controls
X
X 6.4.3
7. Check friction and forces in control system
X 6.4.1
5.4.2 Wings and Fuel System Components in the Central Wing
1. Check fuel system components at spar bridge of center wing.
X X
X 7.4.6
2. Check vent line outlets at end ribs of central wing
X X
X 7.4.6
3. Check function of quick-release couplings (supply lines)
X X
X 7.4.6
4. Clean both coarse filters.
X
X 7.4.6
5. Check fuel filler cap for leakage and for signs of leakage of wing
tanks
X X X
X 7.4.6
6. Check condition and backlash of wing fittings, check securing
device of wing attachment bolts
X X
X 7.1.1
7. Check condition of wing flaps and ailerons, check clearance
between components spanwise 3 ± 0.5 mm / 0.12 ± 0.02 in.
Check gap sealings and fairings on flap/aileron links.
X
X 7.1.1
8. Check all control rods and supports in center wing and wing
attachment area, check unlooseable fastening of spring bolt of
each quick-connector
X X
X 7.3.1
9. Inspect L'Hotellier-connectors of aileron control rod according to
manufacturer instructions (Annex A). Check unlooseable
fastening of safety pin.
X X
X 7.3.2
10. Check bell-crank levers and adjacent components of wing flaps
and aileron system in wing.
X 7.3.2
11. Check swaged terminals of all control rods in wing
X
X
7.3
12. Check condition of airbrakes
X
X 7.3.2
