Maintenance Manual STEMME S10-VT
Date of Issue: Dec. 19, 1997
Page: 5-15
Amendment No.: 23
Date: Jan. 29, 2015
A4011121_B23.doc
Doc. No. A40-11-121
Type and Subject of Inspection
B
re
a
k
-In
A
/C
1
0
0
h
E
n
g
ine
1
0
0
h
E
n
g
ine
2
0
0
h
E
n
g
ine
6
0
0
h
A
n
n
u
a
l
refer to
section
Sign-off
5.4.6 Tail Boom
1. Check elevator bell-cranks in lower vertical fin
X
X 7.3.3
2. Check swaged terminals of all control rods in tail boom.
X
X
7.3
3. Check rudder control cables in forward tail boom.
X X
X 7.3.3
5.4.7 Empennage
1. Check rudder fittings.
X X
X 7.1.3
2. Check connection of antenna cable (bottom of rudder).
X
X 7.1.3
3. Check adjustment and condition of rudder control.
X X
X 7.3.3
4. Check free movement of rudder, especially in case of tail wheel
blockage.
X X
X 7.1.3
5. Check front fitting of horizontal stabilizer for spring tension,
backlash of bolt, fatigue cracks and corrosion.
X X
X 7.1.3
6. Check rear fitting of horizontal stabilizer for wear of pins, fatigue
cracks, axial and radial backlash and corrosion.
X X
X 7.1.3
7. Check tight fit of screw connections of both horizontal stabilizer
fittings
X X
X 7.1.3
8. Check connection of elevator control rod to rear fitting of
elevator.
X X
X 7.3.3
9. Check backlash in fittings of horizontal stabilizer when installed. X X
X 7.1.3
10. Check additional battery (optional): Connections, tight fit and
condition of mounting. Check if the Equipment List and Weight
and Balance Report correspond with the a/c with regard to the
additional battery.
X
X 7.1.3
11. Check gap sealings and zigzag tape on empennage.
X
X 7.1.3
5.4.8 Fuel System Components in the Fuselage
1. Check quick-release couplings in supply line.
X X
X 7.4.6
2. Check condition of supply, return and drain lines outside the
engine compartment, supply and return lines inside the engine
compartment.
X X
X 7.4.6
3. Check condition, attachment and function of electrical fuel
pumps.
X X
X 7.4.6.2
4. Check fuel- cock, fuel- check- valves and drainer. Check fire-
wall penetration assy of supply and return lines for tight
connection and leakage.
X X
X 7.4.6.2
5. Clean fine filters, check condition and change if necessary
X X
X 7.4.6.2
6. Change fine filter
X X 7.4.6.2
7. Check drain lines of carburetor drip trays and airbox
X X
X 7.4.6.2
8. Check fire protective sleeves on fuel supply and return lines in
engine compartment.
X X
X 7.4.8.2
