STEIN300_Radius Circuit_06_GB.doc / 01.2020
19
7
Radius circuit operation
Fig. 7-1:
Radius circuit 90° and
Radius circuit 180°
In normal operation the radius circuit is controlled by the WTS control system.
•
The WT is transported by the belt element to the entry point of the radius circuit
•
After entering the radius circuit the WT is turned through either 90° or 180°
•
At the exit point of the radius circuit, a belt element takes over the onward transport
of the WT.
i
Please note:
The orientation of the WT is not changed by the radius circuits!
See page 12, fig. 4.2.
ATTENTION!
The motor must be operated in continuous operation, or velocity must be reduced
via a brake ramp when turning off the motor.
Abrupt turn off of the motor, can damage the radius circuit (rotating plate)!
