STEIN300_Radius Circuit_06_GB.doc / 01.2020
17
WARNING!
Do not unscrew the adjustable bases (2) of the module too far out!
The threading has to remain firmly within the stand.
Make sure that there is still sufficient thread available to allow for adjustments that
may need to be made after setting up the other modules, to allow for unevenness in
the floor.
Align the radius circuit in the X- and Y-directions.
Turn the adjustable bases with an open-jaw spanner
•
until the module is aligned horizontally in the X- and Y-directions and
•
the junction of the belt element and radius circuit is at the same level and
•
the module stands firmly on the floor on all its feet.
After this adjustment process, screw all the stand base locknuts on the first module
tight.
i
Please refer to chapter 10 for the installation and other dimensions.
5.4
Connection of the radius circuit to the mains supply
DANGER!
Connection to the mains power supply must be carried out exclusively by trained
specialists from STEIN Automation!
WARNING!
Be sure to use only approved plug-and-socked systems when connecting to the
power supply.
i
Further information can be found in the technical description of the
“STEIN 300 Drive Motors”.
5.5
Pile-up separator installation
i
Further information can be found in the technical description of the “Stopping Device”
(SE).
Also see the service video “Stopper replacement”.
