Standard Horizon CP180, Owner'S Manual

Page: 96 / 138

Page 98 GPS Chart Plotters
R
12.5.1 GPS Setup Menu
From this page it is possible to activate the GPS Setup menu following this procedure:
1. Press [MENU] . Move the ShuttlePoint knob to enter GPS STATUS page
and press
[ENT] .
2. Press and hold
[ENT] . The GPS SETUP menu appears on the screen. See the
following table:
Internal GPS : Enables (On) or disables (Off) the Internal GPS. The default setting is On.
Restart GPS : Restarts all GPS processes. Once executed, the message "Done" is shown.
Navigation Speed : Allows setting the Navigation Speed among Low and High. The default setting is
High.
Differential Correction Source : Allows setting what kind of Differential Correction will be used by the GPS between
WAAS-EGNOS and none. The default setting is WAAS-EGNOS.
3.
Move the ShuttlePoint knob to highlight the preferred item and press [ENT] .
4. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the menu disappears.
12.6 NMEA DISPLAY PAGE
The GPS Chart Plotter is capable of displaying information in the customizable data
windows from external NMEA devices. Depth sounder, Speed Log with temp, Wind speed
and direction, Flux gate compass, and GPS information can be shown in any of the boxes.
The default NMEA Display shows 3 windows. When going to a destination, this screen is
useful to navigate as to get to the destination keep the Course Over Ground (COG) and
Bearing (BRG) figures the same.
Figure 12.6 - NMEA Display page
The NMEA sentences read from external devices are: BWC, DSC, DSE, GGA, GLL, GSA,
GSV, HDG, HDM, HDT, RMC, VHW, VTG, DPT, DBT, MTW, VWR, VWT, TLL, WPL, RTE.
CHANGING the NMEA PAGE Windows
1. On the CP180/CP180i, press [MENU] . Move the ShuttlePoint knob to highlight NMEA
DISPLAY and press [ENT] .