Standard Horizon CP180, Owner'S Manual

Page: 24 / 138

Page 26 GPS Chart Plotters
R
Usually the VHF radio will be connected to the Green and Brown wires. To check to see if
the GPS Chart Plotter is transmitting the sentences:
1. Press
[MENU] . Move the ShuttlePoint knob to highlight NMEA DISPLAY and press
[ENT] .
2. Move the ShuttlePoint knob to highlight DATA and press [ENT] .
3. The NMEA DATA page is shown.
4. Connect the Blue Wire on the GPS Chart Plotter to the junction of the Brown wire and
the VHF wire. The display should look similar to the following picture.
Figure 2.11 - NMEA Data page
2.12 CP300/CP300i VIDEO INPUT
By accessing this menu it is possible to see images on the CP300/CP300i display from an
external video signal source, if connected to the CP300/CP300i.
It allows the
"picture-in-picture" functionality, so a Video Input image can be shown on a
window and placed over the Chart, Navigation, Highway, Celestial and NMEA pages image
at full screen.
NOTE
If the Video Input signals is not detected (E.g. the video camera is not connected to the Video Input
connector), the VIDEO INPUT menu item will be greyed out.
Video Connector
Pin Description Connection Example
1 Ground Connect to Video Signal Ground of DVD/VCR/Video Cameras
2 + 9 / 12 VDC Connect to Video Cameras Power Input
3 Video Connect to Video (NTSC/PAL) of DVD/VCR/Video Cameras
2.12.0 Video Camera Input
The CP300/CP300i has one connection for video camera. Any NTSC or PAL camera will
operate correctly. To connect use the video output of the camera and connect to the optional
ACVC10 cable.
2.12.1 VCR or DVD Input
A VCR or DVD may be connected to Video port. The
CP300/CP300i
does not have speakers
so the audio from the VCR or DVD would have to be routed to a stereo system.
STANDARD HORIZON offers an optional cable called ACVC10 that allows any VCR or