SportsPlay QUICK SHIP 1 MODIFIED, Installation Instructions Manual

Page: 67 / 112

September 17, 2014 7
912-807 SAND & WATER PANEL
INSTALLATION INSTRUCTION
INSTALLATION STEPS CONTINUED
__4) Install panel to attachment brackets: Once you have all 4 of
the panel attachment brackets installed. Locate the panel, with a
helper lift the panel into place and mark the holes in the tab of the
panel attachment bracket on the panel. Next you need to drill a1/2”
hole in the panel at the marks you made from the panel attachment
brackets with the dry erase marker.( see detail B)
__5) Install support legs To complete this step you will need the
three 1” Leg Supports (4), three 3/8” Flat Washer (12), three 3/8”
x1 1/4” Button Head Bolt (13) Attach the support legs to the bubble
basin (2) with the bolt and flat washer passing through the basin
and into the support leg. (One end of the support leg will be
threaded See detail F)
__6)
Install the drain assembly: For this step you will need two
12” acrylic domes packed in a separate box, two PVC Bushings
(16), Two PVC Caps (17), Two Conduit Locknuts (18), and two
Large O Rings (19). Once you have located the parts you need
insert the PVC bushing through the hole in the bottom of the dome
with the O-ring installed on the bushing then place the bushing in
the bubble. The O-ring will be on the inside of the bubble. Install
the Conduit Locknut on the PVC Bushing. (Only tighten the
locknut enough to prevent it from leaking) SEE DETAIL E