Spirax Sarco SP8-10, Installation And Maintenance Instructions Manual

Page: 77 / 88

IM-P707-01 CTLS Issue 1
77
SP8-10 Smart positioner
5.1.39 Menu: Service
Menu/parameter Value range Description
Service Mode Off, On* Activate service mode.
Factory Setting* - Load factory settings
Adjust Sensors*
Adjust All,
Adjust Outputs
Note:
The supply pressure and the drive must not be
pressurized for calibration to atmospheric pressure.
Otherwise, the existing pressure is applied as the zero
point.
In order to set the zero point for the pressure sensors,
the pneumatic device connections for the supply air
and actuator must be disconnected and vented. The
sensors will then be calibrated to the atmospheric
pressure.
-
Supply Pressure - Supply air pressure
-
Pressure Y1 - Pressure, output 1
-
Pressure Y2 - Pressure, output 2
Pneumatic*
Single/Safe
Single/Freeze
Double/Safe
Double/Freeze
Use this parameter to adapt the positioner software
to the installed I/P module. This is required when
installing a different I/P module type.
The type of pneumatics that the device works with is
displayed here.
-
Single/Safe - Single acting, safety position with no
current, with venting function
-
Single/Freeze - Single acting, safety position with
no current, with blocking function
-
Double/Safe - Double acting, safety position with
no current, with venting function
-
Double/Freeze - Double acting, safety position
with no current, with blocking function
Remote Sensor* Off, On
If an external position sensor is connected, this
parameter must be set to ‘On’.
Sensor Type*
Standard
Non-Contact
External Sensor
No Linearization
Use this parameter to select the version of the installed
position sensor.
-
Standard - Standard position sensor
-
Non-Contact - Contactless position sensor