LiQuilaz II E and S Operations Manual
Page G-1
Appendix G
Serial Setup Command List
Definitions of serial setup commands are provided in this appendix.
NOTE:
The characters at the end of a command word that appear in
brackets “()” are optional.
Serial Setup Command List
Table
G-1
Serial setup command list
Command
“?” or “help”
Print an on-line command summary. The summary contains the
following text:
?
or
help
-- Yields this message
data
-- Toggles data dump on/off
default
-- Set IP parameters to defaults
nvsram
-- Dumps contents of non-volatile storage
reset
or
reboot
-- Reset/reboot the hardware
set gateway ddd.ddd.ddd.ddd
-- TCP: sets the gateway address
set ip ddd.ddd.ddd.ddd
-- TCP: sets the IP address in decimal
set led n
-- Sets LED mode 1=connection, 0=status
set mask ddd.ddd.ddd.ddd
-- TCP: sets the network mask
set mode n
-- Ethernet: Mode 0=PMS, 1=Modbus
set multicast ddd.ddd.ddd.ddd
-- TCP: sets the multicast address
set ntp ddd.ddd.ddd.ddd
-- TCP: sets NTP Server address
set queue n
-- Set data queue between 1 and 1440
set sample n
-- Sets the sample interval to n secs
set serdump n
-- Sets the device to dump data at boot, if 1
set telnet n
-- TCP: Telnet enabled, if 1
set inst float n
-- Ethernet: Modbus float, if 1
set inst ntp n
-- Ethernet: NTP Client enabled, if 1
set inst retro n
-- Ethernet: Retro mode for Facility Net, if 1
status
-- Displays the current settings
write
-- Save all parameters and reset
