SpectraLink Corporation
Installation, Configuration, and Administration
NetLink Telephony Gateway
Part Number: 72-0065-02-R.doc
Page 40
13.
NetLink Telephony Gateway Configuration
Select
Gateway Configuration
from the
NetLink Wireless Telephone System
menu.
Scroll to remaining option:
The options listed below with the arrow bullet
¾
are minimal settings required for
NetLink Telephony Gateway functioning. Do not change settings until you have
studied this section and are familiar with the consequences any change will produce.
Where available,
S=Send All
may be used to send identical configuration settings to
every other NetLink Telephony Gateway in the system.
¾
Telephone Switch Type
: Press Enter to change this field. From the sub-menu of
PBX types, select the telephone switch type you are using.
¾
Use SVP100 for QOS
: This must be set to
No
when using four or fewer gateways
with the IPC cables and no NetLink SVP Server It must be set to
Yes
when using a
NetLink SVP Server.
Gateway ID Number
: For a Norstar PBX, this should be set to a unique number for
each Gateway. Every other system should retain the default.
Flash Delay Time
: (analog interface only) The time the system should wait after the
“on-hook” flash signal ends before allowing other keys to be transmitted to the host
telephone system. The allowed range is from .01 to 2 seconds. The value depends on
the requirements of the host telephone system.
