Spectra Watermakers VENTURA 150, Installation And Operation Manual

Page: 31 / 74

31
Start
Pressing the ‘ Start ’ button begins watermaker
operation.
If the system has been pickled, winterized, this is the first startup, or the condition of the system is
unknown, go to NEW SYSTEM START
- UP on page 28 or serious damage may occur.
A fresh water flush should be performed after every use of the watermaker. The system will need
to run for approximately half an hour to make enough fresh water for one flush.
Fresh Water Flush (FWF)
Pressing the ‘ Fresh Water Flush ’ button floods
the watermaker with fresh water from the
vessel
’ s domestic water tanks. Opens solenoid
valve to allow water to flow from tank instead of
seawater from the thru
- hull. Fresh Water Flush
mode will end automatically after flush is
complete, approximately 3 minutes.
Stop
Pressing the “ Stop ” button ends watermaker opera-
tion. The “ Stop ” button must be pressed before
beginning a Fresh Water Flush.
Fault Light
The “ Fault ” light indicates that there is a
problem with the system, usually caused by
too much or too little pressure in the feed
water or membrane pressure vessel.
Spectra Manual Remote Controller Guide