Specialized Stumpjumper FSR, User Manual, Page: 18 / 28

15
5
„
Once both tubes are bottomed out against the lip of the exit port holes, install a set screw and thread it in until it
is flush with the exit port. Press on the inside of the tube against the set screw to seat the tubes (see fig.7 inset).
6
CUT
5mm
„
Gently pull any excess tube out of frame from the chainstay ports.
When gently pulling the tubes out from the chainstay ports, be sure to not pull the tubes from the
head tube port. Only pull enough to find its natural curvature position within the frame.
„
Use a new/sharp heavy duty cutting blade to trim the guide tubes about 5mm past the edge of the exit port (see
inset). Match the cut angle with the guide port exit angles.
Place a protective strip between the chainstay and the tube, so the razor blade doesn’t damage
the finish of the frame.