Specialized Stumpjumper FSR, User Manual, Page: 15 / 28

12
5. INTERNAL ROUTING (CARBON FRAME)
5.1. DROPPER SEATPOST
To simplify assembly, always install the seatpost housing before the shift and brake housings.
Make sure the SWAT latch and dropper post plastic tube are installed in the frame before routing
the dropper housing.
MOLDED
TUBE
PLASTIC
TUBE
SHIFT
HOUSING
SWAT
LATCH
PLASTIC
TUBE
1
„
Route the seatpost housing into the drive side exit port near the head tube. As it exits the molded tube in the
down tube near the top of the SWAT hole, it may be necessary to guide the housing into the plastic tube (held in
place by the SWAT Latch) going from the SWAT hole to the bottom bracket area and up the seat tube.
„
Once the housing is going up the seat tube, it may want to go up the side-arm instead of up the seat tube. If this
happens, cut a long, narrow strip of card stock paper or use a long, thin ruler to slide down the seat tube and
block access to the side-arm.
„
Once the housing exits the top of the seat tube, install the seatpost according to the manufacturer’s instructions.