Specialized Stumpjumper FSR, User Manual, Page: 17 / 28

14
3
MARK
„
Install the rubber boot into the routing port behind the main pivot.
„
Guide the tubes up through the side-arm, top tube, then out the bottom of the head tube.
„
Align the chainstay bearings and spacers with the main pivot location of the frame, then loosely install the bolts.
„
At this point, all remaining pivots should be assembled. Torque the bolts according to the order described in
section 4.4,
page 6 .
Make sure the tubes aren’t wound around each other.
15mm
4
SHARP SCREWDRIVER
OR NARROW CHISEL
„
Slide the brake guide tube back into the frame by gently pulling from the chainstay end until the tube is about
15mm past the rearward edge of the head tube port.
„
Use a 4-5mm OD center-punch to guide the brake guide tube into the lower head tube port until it bottoms out
(15mm insertion).
„
Repeat the process for the shift tube through the upper exit port.
You can gently push the guide tubes into the head tube ports from behind the port assembly using
a sharp screwdriver or narrow chisel.