Operating instructions BMK-20i | Heinz Soyer Bolzenschweißtechnik
17
Incorrect use
Any use of the welding gun deviating from the intended use is considered improper
use.
Non-intended use, unauthorised modification or manipulation of the device will void the
declaration of conformity as well as all warranty claims against the manufacturer.
Misuse of the welding gun as a tool, e.g. as a hammer for checking the weld quality, is
not permitted.
2.7
Requirements on the part of the operator
The operator of the device must ensure that the preconditions described in this
operating manual regarding safe operation of the device are met.
These include, for example, the conditions at the installation location, regulatory
requirements for a safe workplace, training of the operating personnel and qualified
personnel in using the device, if applicable, compliance with required maintenance work
as well as monitoring the intended use of the device.
These operating instructions must be stored in the vicinity of the stud welding device.
The operator of the device must ensure that all protective devices are present, active
and intact before the stud welding device is used.
Please observe the DIN EN IEC 60974-9 standard (arc welding equipment - part 9:
Installation and operation) in the currently valid version.
Prerequisites for personnel
Operating personnel
The persons authorised to operate the device must be familiar with the stud welding
device and trained accordingly. They must have read and understood these operating
instructions. When working with the stud welding device, they must also be able to avert
possible residual danger to themselves and third parties or minimise them as far as
possible.
To maintain the qualification, safety training must be carried out at least once a year. In
the event of malfunction or for maintenance, specially trained personnel or the
manufacturer must be consulted, if necessary.
Operators of stud welding equipment must have technical expertise for operating and
adjusting the devices properly as well as for properly carrying out weldings.
If welding personnel have to be qualified for certification of welding, the DIN EN ISO
14555 and DIN EN ISO 14732 standards are to be observed.
Summary of Contents for SRM EcoWeld BMK-20i
Page 2: ......