SA263
Collider Delay+Reverb Owner’s Manual
34
5.
Move the knobs you wish to control with the external footswitch to the minimum desired
position and then click the DELAY/TAP footswitch. The C
ONTROL
L
ED
will now blink even
faster (about 4 blinks per second). Note that you may control up to three knobs.
6.
Move the knobs you wish to control with the footswitch to the maximum desired position
and then click the DELAY/TAP footswitch. The C
ONTROL
L
ED
will now be lit solid red.
7.
After setting the minimum and maximum knob positions, the parameter mapping is
complete.
External Switch as Expression Toggle (
1/8” (3.5mm)
TRRS Connection
–
CONTROL INPUT
Jack)
To use this mode, connect an external switch to C
ONTROL
I
NPUT
and set the P
EDAL
I
N
S
WITCH
to the
S
WITCH
position instead of the E
XP
position. The following plug configuration is required:
Follow these steps for configuration:
1.
Press the C
ONTROL
I
NPUT
B
UTTON
to enable external control. The C
ONTROL
L
ED
should be lit
red.
2.
Press and hold the C
ONTROL
I
NPUT
B
UTTON
until the C
ONTROL
L
ED
begins to blink slowly
(approximately one blink per second).
3.
Tap the external switch once.
4.
Click the DELAY/TAP footswitch once. The C
ONTROL
L
ED
will blink faster (about 2 blinks per
second). Now, it is time to map the external switch to the effect parameters.
5.
Move the knobs you wish to control with the external footswitch to the minimum desired
position and then click the DELAY/TAP footswitch. The C
ONTROL
L
ED
will now blink even
faster (about 4 blinks per second). Note that you may control up to three knobs.
6.
Move the knobs you wish to control with the switch to the maximum desired position and
then click the DELAY/TAP footswitch. The C
ONTROL
L
ED
will now be lit solid red.
7.
After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Hot Hand Input
The Hot Hand 3 Wireless Effects Controller can be connected directly to the C
ONTROL
I
NPUT
jack for
wireless motion control of the Collider Delay+
Reverb’s
effect parameters. The Hot Hand has two axes
of expression: X and Y. These signals are carried on the two rings of the TRRS cable that comes from
the Hot Hand receiver. The Collider uses the X expression signal.
Gr ound
Switch Out
Power (Switch pul l -up)
1/ 8
” (3.5mm
)