Source Audio Collider Delay+Reverb, User Manual, Page: 31 / 51

SA263
Collider Delay+Reverb Owner’s Manual
31
External Switches
(1/8” TRRS Connection)
The Source Audio Tap Tempo footswitch can also be connected to the CONTROL INPUT jack using a
3.5mm (1/8 inch) cable. By default the CONTROL INPUT jack is assigned to Neuro Hub or External
Expression Control. If you wish change the function
of this connection, it can be done with “Control
Input Function” dropdown menu
in the Hardware Options section of the Neuro Desktop Editor. The
alternate options are Increment Preset, Decrement Preset, and Tap Tempo. These are global settings.
Source Audio Tap Tempo footswitches can be purchased directly from the Reverb.com Official Source
Audio Online Store.
External Expression Control
A variety of the
Collider’s
effects parameters can be controlled with a passive expression pedal
connected to either the PEDAL IN or the CONTROL INPUT jacks. The expression pedal can be mapped
to simultaneously control any combination of up to three knobs. Mapping parameters can be done
either in the
External Control section of the Neuro Desktop Editor or with the pedal by itself (see the
Configuring Expression Pedal section for instructions on mapping knob parameters to an expression
pedal without the Neuro Desktop).
External Expression Controller (1/4”
TRS Connection
–
PEDAL IN jack)
Passive expression pedals such as the Source Audio Dual Expression Pedal can be connected directly
to the 1/4" P
EDAL
I
N
jack with a TRS cable. Make sure that the PEDAL IN switch (next to the PEDAL IN
jack) is set to EXP when using this input for expression control. Third-party expression pedals can be
used as well, as long as they have a TRS (Tip Ring Sleeve) plug with power on the ring, expression (the
wiper of the potentiometer) on the tip, and ground on the sleeve, as seen in the diagram below.
Please note, expression pedals with TS (Tip Sleeve) plugs will not work correctly with the expression
input (P
EDAL
I
N
jack) of the Collider. Also, the resistance of the expression pedal is not critical. Pedal
calibration is done automatically when a new external control mapping is created.
External Expression Controller (1/8
”
/3.5mm TRRS Connection
–
CONTROL INPUT jack)
The Source Audio Dual Expression Pedal can be directly connected to the C
ONTROL
I
NPUT
jack using a
3.5mm (1/8 inch), TRRS cable. In the case of an expression pedal with a TRRS plug, the tip connection
is power, the first ring is the X-axis expression signal, the second ring is the Y-axis expression signal,
Gr ound Power
Expr ession