SA263
Collider Delay+Reverb Owner’s Manual
18
Hardware Shortcuts
The Collider comes with many “hidden” controls and features that will help you calibrate the pedal to
your specific needs. There are two types of shortcuts: “Normal” shortcuts that are done without
changing the power of the pedal, and “Power
-
Up” shortcuts
that are options set by depowering and
repowering the pedal.
Normal Mode Shortcuts
Trails Mode
: To toggle Trails Mode for your delay/reverb, hold the CONTROL INPUT button on
the top side of the pedal, and press the DELAY/TAP switch. The Control Indicator LED will flash
once for Trails Mode OFF, and twice for Trails Mode ON.
Preset Extension Mode
: To toggle Preset Extension Mode, which doubles the amount of
available preset slots from 4 to 8, hold the CONTROL INPUT button on the top side of the pedal,
and press the PRESET SELECT Button.
Adjust Delay Time Division
: To toggle between stereo delay time divisions, hold the CONTROL
INPUT button while moving the DELAY knob. There are four divisions spread out evenly across
the knob.
Hidden Output Level Knob
: To access the hidden “Output Level” knob, hold the CONTROL
INPUT button while moving the MIX knob. This will control the overall output of the Collider.
Unity gain is at 12 o’clock.
This combination is also used to control the level of the dry signal
when the effects are in Parallel Mode.
Cascade/Parallel Mode Toggle
: To toggle between Cascade and Parallel Mode on the pedal,
hold the Control INPUT button down while flipping the “KNOBS” switch to the center “LOCK”
position. If your switch is already in this position, flip it to either side and then back to the center
while holding the CONTROL INPUT button.
Power-Up Shortcuts
Factory Reset
: To perform a factory reset on the Collider, unplug the power cable. Then, press +
hold the REVERB Footswitch while plugging the power supply back in.
Disable Internal Tap
: To disable the integrated Tap Tempo feature located on the DELAY/TAP
Footswitch, unplug the power cable. Then, press + hold the DELAY/TAP Footswitch while
plugging the power supply back in. The DELAY/TAP LED Indicator will flash once for disabled,
twice for enabled.