SA263
Collider Delay+Reverb Owner’s Manual
23
Auto Routing and Default Modes
By default, the Collider detects what has been plugged into its inputs and outputs and sets the
routing mode automatically. The table below summarizes each Auto Routing Mode and its
corresponding cable connections.
Warning
: If you connect the Neuro App cable from your mobile device to INPUT 2, the Collider will
detect it as an audio input and adopt one of the Stereo In Modes, which might create additional noise
and affect the stereo signal. This is especially true when the Neuro App cable is not connected to the
phone. You can override this action by going into the app and selecting the Mono In routing mode
that you want. If you want to connect a stereo input AND the Neuro App cable into INPUT 2, use a
TRS (Tip, Ring, Sleeve) stereo splitter and make sure that the Neuro signal is on the Ring and the
instrument signal is on the Tip (the Sleeve acts as the ground).
Auto Routing Modes
There are four routing modes available when the Collider is in its default Auto Detect mode. See
detailed descriptions of each Auto Detect mode in the sections below.
•
•
•
•