SA263
Collider Delay+Reverb Owner’s Manual
20
1.
Click the SELECT button to cycle through the hardware user presets. This function works
whether the pedal is engaged and bypassed.
2.
When the effect is bypassed, press and hold down the REVERB footswitch to cycle forward
through presets. Release when you’ve arrived at your desired slot. Press and hold
the
DELAY/TAP switch to cycle backward through presets. If Reverb is engaged you will not be able
to cycle forward through presets, and vice versa.
3.
Connect an external footswitch to the PEDAL IN jack and select SWITCH mode (located next to
the PEDAL IN jack) to scroll upward through presets. Please note that
the Collider’s default
external switch assignment is Tap Tempo, but it can be easily changed to Increment or
Decrement Preset in the
section of the Neuro Desktop or Mobile App
Editors. These control assignments are global.
Recalling MIDI Presets
All 128 available User Presets are accessible with an external MIDI controller. MIDI controllers can be
connected via either the 5-Pin DIN (MIDI IN) jack on the side of the pedal, the USB port at the top of
the pedal, or through a Neuro Hub, which connected to the CONTROL INPUT at the top of the pedal.
All 128 User Presets can be recalled with the corresponding MIDI program change (PC) messages.
Note:
When recalling presets via MIDI PC messages, you may wish to queue up your preset with
effect bypassed. To do this, simply engage the preset, bypass it with both footswitches, then re-save
the preset normally. When recalled, the pedal will load the saved user settings, but the effects will be
bypassed until you engage either engine.
Copying a Preset to a New Location Using the Select/(Hold) Save Button
1.
Select the preset you would like to copy by pressing the SELECT Button until the corresponding
P
RESET
LED is lit.
2.
Press and hold the SELECT Button for one second until the corresponding P
RESET
LED begins
blinking rapidly. Quickly release the SELECT Button. The P
RESET
LED should continue to blink
rapidly. This indicates that the Collider is in copy mode.
3.
Tap the SELECT Button to increment the preset. The corresponding P
RESET
LED should continue
to blink rapidly. Tap the SELECT Button again until the desired copy destination is selected.
4.
Press and hold the SELECT Button until the P
RESET
LED blinks slowly and then turns solid. This
indicates that the preset has been saved to the new location. The original location will not be
changed or overwritten.
Copying a Preset to a New Location Using an External MIDI Controller
1.
Select the preset you would like to copy by sending a MIDI program change message to the
Collider.
2.
Press and hold the SELECT Button for one second until the corresponding P
RESET
LED begins
blinking rapidly. Quickly release the SELECT Button. The P
RESET
LED(
S
) should continue to blink
rapidly. This indicates that the Collider is in copy mode.
3.
Send a desired MIDI Program Change number to indicate the desired copy destination for the
preset.
4.
P
RESET
LED will blink fast and then turn solid. This indicates that the preset has been saved to
the new location.