SoundCraft Vi1, User Manual

Page: 2 / 217

Soundcraft Vi1™ User Guide Issue 0910 ii
© Harman International Industries Ltd. 2010
All rights reserved
Parts of the design of this product may be protected by worldwide patents.
Part No. BD10.947002 Rev1 Issue 0910
E&OE September 2010
Soundcraft is a trading division of Harman International Industries Ltd. Information in this
manual is subject to change without notice and does not represent a commitment on the
part of the vendor. Soundcraft shall not be liable for any loss or damage whatsoever arising
from the use of information or any error contained in this manual.
No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any
form or by any means, electronic, electrical, mechanical, optical, chemical, including photo-
copying and recording, for any purpose without the express written permission of Soundcraft.
Harman International Industries Limited
Cranborne House, Cranborne Road, Potters Bar, Hertfordshire, EN6 3JN, UK
Tel: +44 (0)1707 665000
Fax:+44 (0)1707 660742
http://www.soundcraft.com
IMPORTANT
Please read this manual carefully before using your mixer for the first time.
®
This equipment complies with the EMC directive: EMC 2004/108/EC
And low voltage: Low Voltage 2006/95/EC
This product is approved to safety standards:
IEC 60065:2001 + Amd 1:2005
EN 60065:2001 + Amd 1:2006 + A11:2008
UL 60065-07, CSA C22.1 No 60065-03 + Amd 1:2006
And EMC standards: EN55103-1:2009, EN55103-2:2009
Warning: Any modification or changes made to this device, unless explicitly approved by
Harman, will invalidate the authorisation of this device. Operation of an unauthorised device
is prohibited under Section 302 of the Communications act of 1934, as amended, and
Subpart 1 of Part 2 of Chapter 47 of the Code of Federal Regulations.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna
* Increase the separation between the equipment and the receiver
* Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
* Consult the dealer or an experienced radio/TV technician for help
For furtherr details contact
Harman International Industries Ltd, Cranborne House, Cranborne Road, Potters Bar, Hertfordshire EN6 3JN, UK
Tel44(0) 1707 665000 Fax +44 (0)1707 660742 email: soundcraft@harman.com